SNE Warehouse Toshiba BEV4 Label Printer

Files/Drivers location: "\\fs01\install$\applications\Toshiba TEC Printer"

Media Type: DT (Direct Thermal)

Label Size: 4" w x 6" h

Calibration Tool: SettingTool_V017.exe
Maintenance Tab, Select Trans. then Send. Printer will push through a couple sheets then calibrate.

To check the sensor type applied: Turn off Printer, Hold Feed Button, Turn on Printer, When the light turns green after it cycles through its colours (Should be 20 seconds or so). This will print out a report, the sensor setting should be to Trans.

To change the sensor type: While the printer is on, open the lid, when the light goes out hold the feed button until it turns solid Green. Let go of the feed button and wait for it to turn Red (it will go Green -> Orange (Green and Red LED on at the same time) -> Red) then push Feed again.

You may have to calibrate the sensor again after this.